Toshiba 51H94 - Viewing the Digital Signal Meter; Viewing the System Status

Viewingthe digital signal meter
Yoltcan _iew the digka_ sigpm_meter fbr ANT 1 and ANT 2
digkai TV iplpursources only,
To view the digital signal meter:
1. Press MENU aM open the SETUP memo.
2, Highlight INSTALLATION and press ENTER. (A new set
of INSTALLATION memt icons will appear on-screen, as
shown in step 3 below,)
i _ ¸¸!!%
_ N avig at e
¢_{iSeleet _Back _/,_Exit
3. Open the TERRESTRIAL mentt, highlight SIGNAL
METER, and press ENTER.
_#Navigate _Se]eot _l_;HiBaok _ExJt
4. Use the A'q@ _ battens to sdec; the antepma input and
digital chamM whose signal you want to check.
NOteJ The ph_%/CH/ cJiq/_g_/ chsRF]8/ r_u(]?De_ /15780 JR the 5;/igr_81
Meat saee/i may not coffespond a a vizZualTVchannel
IltJIT_bet: CofF_ct yot]r /oca/ btoadcastef:v I_) obt_df? the RF
chsRne/ nt/ff_befs tel your Iota/d/_jlt_d stat/ofTs
To close the screen and return to the TERRESTRIAL menm
kIighfight OK and press ENTER.
To return to normal viewing:
Press EXIT.
Viewingthe system status
To check the system status:
1. Press MENU and open the SETUP memt.
2. Highlight INSTALLATION and press ENTER. (A new set
of INSTALLATION memt icons will appear on-screen, as
shown Jr1step 3),
3. Open the SYSTEM STATUS mentt, high[ight SYSTEM
INFORMATION, and d_en press ENTER.
Navigate @Select _t_:_Back _;!_ExJt
@Navigate @Select _¢_]Back _/gExit
4. Use the "_ _ Ixtt[ons to scroll through the memt bar to
check the Product Inf))rmation and Sofnvare Versiom
0,
To close the screen and return to the INSTALLATION
menm HigNight OK and press ENTER,
To return to normal viewing: Press EXIT,
Restore Factory Defaults
To restore all settings and cha*mels to their f_ctory def_mk
vaktes:
1. Follow steps 1-3 abo_e.
2. Use the @ _ bttttons to scroll through the menu bar to
select FACTORY DEFAULTS.
3. The screen below left appears. Enter vottr PIN code (or
0000 if no PIN code has been set). T'he screen bdow right
appears.
To cancel the reset: HigNight NO and press ENTER.
To continue the reset process: HigNigh_ YES and press
ENTER. The TV will turn off'au[omaticaIIy after a tbw
seconds. After the TV turns off] tmpIug d_eTV power cord
and then pIt*git in again to complete the reaore.
This window provides the ability to reset
the TVsettings.
Type in your PiN now (or "0000" if no PIN
has beenset)to lestole settings to their
actory de au tva ues.
÷
H94(E)0444
52
2(6b-Setup)
52
Copyright @ 2004 TOSHIBA CORPORAl[ON. All rights reserved.
÷
813/04, 5:28 PM
[