A ÷ [
Connecting a digital audio system
The TV's DIGITAL AUDIO OUT jack outputs a
p[_ or>chap.le_dow>mi_edPCM(p<se<ode
meduhtion) signal fbr use with an external Dolby Digital
decoder or other external audio system with optical audio inpus.
You will need:
¢ one optical audio cable
To control the audio:
Tim1on the TV and the digital audio device.
Press MENU on the TV's remote centre[ and open the AUDIO
lnenu,
Highlight AUDIO SETUP and press ENTER.
hi the OPTICAL OUTPUT FORMAT rid& select either
DOLBY DIGITAL or PCM, depending <7,1your device (see
"Selecting the optical audio out Jut tbrmat" o,1 page 83).
Turn elf the TV's builtdil speakers in the same AUDIO SETUP
menu (above). Also see "'Fuming eli"the buih-in speakers" on
page 83.
"[!/
Note:
* SomeaudiosystemsmaysTotbecompatiblewithDolbyD/_qit;#bii:,__ti_m
S/qflSi5 Older 8ucI/o sysl_ms I</K_[[2re Rot compat##e wit/?Stt2fKJtff_]
optics/out s/qf78Ls<178ynot WOlRpmpe#y, c/_ating a h_lh sic/solevel that
frlay d;lmgggespeake/s of heao_phof?esTHIS DAMAGE IS NOT
COVERED BY YOUR WARRANTY
* 21e DIGITAL AUDIO OUI)iac, k may not output some d/d/t_#audio
soteees because of c'opy f_St/fet/of_&
The unauthorized recording, use, distribution, or revision of television
programs, videotapes, DVDs, and other reaterials is prehibRed under the
Copyright Laws of the United States and other countries, and may subject
you to civil and crireinal liability,
÷
Connecting an analogaudiosystem
This connection aJbws you to use external speakers with an
external audio amplifier to adjust the sound level
You will need:
one pair ofs_andard audio cables
To control the audio:
"[1/
Turn o,1 the TV and the stereo amplifier.
Tim1 off the TV's built-in speakers (see "Timling off the buihdn ....................
speakers" on page 83).
Note: 7bheat soundwhel_usinganexteme,/auo'ioampl#/e/;
the volumeU both the TVand the3)lT]pl//:/ef must beset I_)a
masonabbl/sten#wbveL
20
H94(E)0124 (2B-Cnct)
2O
Copyright @ 2004 TOSHIBA CORPORATION. All rights reserved.
÷
813/04, 3:42 PM
[
To Next Page
Loading...
