Toshiba 51H94 - Selecting the Video Input Source to View

Selectingthe videoinput source to view
To select the video input source to view:
1. Press INPUT on the remote conrail or TV/VIDEO on d_e
TV front p;meL
2, Press 0-7 to sebct the inpu_ source you want to vbw,
depending on which input jacks )x_u used for connecung yore'
devices (see Ch;_pter 2).
The current signal source disphys in d_e top right corner of
the INPUT SELECTION screen.
Note:
• While the leput Selectian sc/een £ open, yau also can i_se the AT
buttons on the f_mote COfTtf()/ (OF the Ohannd _,_ buttons on the
front panel_)to d_aege #m /flptJ[
• While #_e/nput Sebctk_n semen £ not open you can mpeatec//y
press the/NPUTbutton of 7the fwnote centre/at i'he I]!/V/DEO
button on the TV fiont pand to d_afwe tim inpu£
° ff_selectan/EEE Z394 bputsouroe, press the TheaterlVet
DEW(.:/: buttonon the remote cont/d (see page 442
° ffan IEFE 1384 device is the otJlT_ntkl/)Ut, it will appear at the
bo_ofTI of the Input Sebct/on //_t howeve< it will be f_/nol/ed f/ofrl
#_e list if the &put soufoe IS d?aeged
• X_u can/abd the video &put soufPes accafdieg to the _pec'ifiL"
devices you have connected to the T1/(see next pnge)
• Thesou/tee can be '?ffdden" See page 68 for dehff£
° ffyou t___ethe TI/_ remote cant/d to st_fft recotdng, yau will not
be abb to change klputs cJulingf_COldie9'
ffyau use a device other #_an the 71/_ remote central to start
mcordied and then change bpuls, the recorded audio and video
i_naybe affected
SLOWSmJ_ S_IPJS_I_C_
Numbers
CHANNEL ,_"
W front panel
MENU VOLUME CHANNEL EXIT W/VID EO P_ch E_J_S
÷
H94(E)O67-76(8a-UseTV)
67
Copyright @ 2004 TOSHIBA CORPORATION, All rights reserved,
÷
8/3/04, 6:08 PM
67
[