Toshiba B-EP Series - Page 23

21
[EURO Font Code]:
Set printer font characters you want to assign to EURO fonts.
Enter two alphanumeric character from “0” to “F.”
Entries are not case-sensitive.
Two characters indicate one HEX character. (Example: “0”  “30” or “A”  “41”)
Range: 20 to FF
[Maxi Code Spec]:
Select a type of barcode font to create a MaxiCode.
Options: TYPE 1 (Interchangeable specification)
TYPE 2 (Interchangeable specification)
[Notice] Group
[LCD Language]:
Select a language of messages to be displayed on the LCD.
Options: English German French Dutch
Spanish Japanese Italian
[Buzzer Volume]:
Select buzzer volume.
Options: OFF
Minimum
Intermediate
Maximum
[LCD Density]:
Select density of display on the LCD.
Enter a number.
Range: -5 to 5
[Command] Group
[Control Code]:
Select a control code used for command analysis.
Options: AUTO
[ESC], [LF], [NUL]
{, |, }
[Print Mode]:
Select an issue mode.
Options: LABEL RECEIPT RECEIPT1
ESC/POS TPCL TPCL1
[Power Save] Group
[Time to the power save mode]:
Set a period of time from when the printer ceases to be used until it enters power save mode.
Enter a number.
Range: 1 to 30 (seconds)
[Auto Power-off Time]:
Set a period of time from when the printer ceased to be used until the printer power is automatically
turned off.
When 0 is set, the power is not turned off automatically.
Enter a number.
Range: 0 to 300 (minutes)
[LCD Back Light Off Time]:
Set a period time from when the printer ceases to be used until the LCD backlight goes off.
Enter a number.
Range: 0 to 30 (seconds)