Toshiba B-EP Series - Page 24

22
[Printer ID] Group
[ID Number]:
Assign the printer with an ID for identification.
This ID is used when IrDA: TEC Protocol is used.
Enter a 5-digit number. If the number of digits is less than 5, the number is padded with zeros.
Range: 00000 to 65535
[Destination] Group
[Destination]:
Select a destination.
Options: Japan
International
[XML] Group
[XML]:
Select whether or not XML is enabled.
To enable XML, select TPCL or TPCL1 as a print command mode.
Options: Disable
Enable
[Adjustment] Group
[Feed Position]:
Set a fine adjustment value for print position in units of 0.1 mm.
When the parameter is not retrieved, the value on the PC set with the print position fine adjust command
[AX] becomes 0.
Range: -50.0 to +50.0 mm
[X-coordinate]:
Set a fine adjustment value for the origin coordinate in X direction in units of 0.1 mm.
Range: -99.9 to +99.9 mm
[Print Density]:
Set a fine adjustment value for print density.
When the parameter is not retrieved, the value on the PC set with the print density fine adjust command
[AY] becomes 0.
Range: -30 to +30
[Strip Position]:
Set a fine adjustment value for strip position in units of 0.1 mm.
When the parameter is not retrieved, the value on the PC set with the print position fine adjust command
[AX] becomes 0.
Some values cannot be set on the printer V1.0B or lower. Set such a value through key operations.
Range: -2.0 to +3.0 mm
[Sensor] Group
[Reflective Sensor Threshold]:
Set a fine adjustment value for threshold to the reflective sensor output in units of 0.1 V.
Range: 0.0 to 4.0 V
[Transmissive Sensor Threshold]:
Set a fine adjustment value for threshold to the transmissive sensor output in units of 0.1 V.
Range: 0.0 to 4.0 V
[Strip Sensor Sensitivity]:
Select strip sensor sensitivity.
Options: AUTO
Low
High