23
[Basic] Group
[Basic Interpreter]:
Select whether or not the basic interpreter is enabled.
To enable the basic interpreter, select TPCL or TPCL1 as a print command mode.
When “Enable” is selected on the printer V1.0B or lower, the “B-EP Setting Tool” is disabled. Select
“Disable” through key operations.
Options: Disable
Enable
[Basic Trace]:
Select whether or not the basic trace is enabled.
Options: Disable
Enable
[Action] Group
[Headcheck at power on]:
Select whether or not broken head dot check is enabled when the power is turned on.
Options: Disable
Enable
[Headcheck at cover close]:
Select whether or not broken head dot check is enabled after the cover is closed.
Options: Disable
Enable
[Printing with broken dots]:
Select whether or not printing continues after a broken head dot error occurs.
Options: Disable
Enable
[Feed at cover close]:
Select whether or not print position detection feed is performed after the cover is closed.
Options: Disable
Enable
[Mode] Group
[Head output division(Print speed)]:
Select a head output division method.
B-EP2DL-GH-QM/B-EP2DL-GH B-EP4DL-GH/B-EP4DL-TH
Options: AUTO 1 (High) AUTO 1 (High)
AUTO AUTO
3 div. (Low) 6 div. (Low)
[B-SP2D mode]:
Select whether or not the compatible mode is enabled to obtain print results same as on the B-SP2D.
Options: Disable
Enable
[Linerless label mode]:
Select whether or not labels without backing paper is used.
Options: Disable
Enable
[Issue mode]:
Select printer’s issue mode.
When “AUTO” is selected, operation depends on strip sensor status.
Option: AUTO
Batch
Strip
To Next Page
Loading...
