Toshiba B-EP Series - Page 29

27
[IrCOMM Status Response]:
Select whether or not automatic status response is enabled in IrCOMM communication.
Options: Disable
Enable
[RS-232C] Group
[RS-232C I/F]:
Select whether or not RS-232C communication is enabled.
To enable it, set a communication baud rate and parity.
Data length is fixed at 8 bits, the number of stop bit is fixed at 1 and flow control is fixed at XON/XOFF.
Options: Disable
Enable
[Baud rate]:
Set a communication baud rate.
Options: 9600 bps
19200 bps
38400 bps
57600 bps
115200 bps
[Parity]:
Set communication parity.
Options: Even
None
[Bluetooth] Group
This group can be set up only on Bluetooth model printers.
[Bluetooth I/F]:
Select whether or not Bluetooth communication is enabled.
Options: Disable
Enable
[Device Nickname]:
Assign a nickname to the Bluetooth device.
This name is used for detection by other devices.
Enter up to 32 alphanumeric characters.
When no name is entered, “TOSHIBATEC BT” is used.
[Inquiry]:
Select whether or not a response is made to an inquiry from the host.
When selecting “Enable (60 seconds),” a response is made to an inquiry only within 60 seconds after
the printer is turned on.
Options: Disable
Enable (60 seconds)
Enable
[Inquiry/Page Interval]:
Set an interval between responses to an inquiry or connection from the host.
Connectivity may be improved by decreasing the value under the environment where connection takes
time.
However, a small value causes printer power consumption to be increased.
Range: 18 to 4096
0.625 msec. per unit
Inquiry/Page Interval ≥ Inquiry/Page Window
[Inquiry/Page Window]:
Set s window of response to an inquiry or connection from the host.
Connectivity may be improved by increasing the value under the environment where connection takes
time.
However, a large value causes printer power consumption to be increased.
Range: 18 to 4096
0.625 msec. per unit