31
[Protocol] Group
[LPR]:
Select whether or not communication according to the LPR protocol is enabled.
Options: Disable
Enable
[Socket]:
Select whether or not socket communication is enabled.
Options: Disable
Enable
[Port Number]:
Set a port number used for socket communication.
Range: 0 to 65535
[Server] Group
[Host Name]:
Set a host name.
When no name is entered, the printer‘s MAC address is used.
Use up to 32 alphanumeric characters to enter a name.
[WINS]:
Select whether or not the WINS protocol is enabled.
When “Enable (STATIC)” is selected, [WINS Server Address] is used.
“Enable (DHCP)” is selected, [DHCP] is used.
Options: Disable
Enable (STATIC)
Enable (DHCP)
[WINS Server Address]:
Set the address of the WINS server.
[DHCP]:
Select whether or not DHCP clients are enabled.
Options: Disable
Enable
[DHCP ID]:
Set a DHCP ID, using up to 64 characters from “0” to “F.”
Entries are not case-sensitive.
Two characters indicate one HEX code. (Example: “01AB” “30314142”)
Entering an odd number of characters results in an error.
[WLAN Basic] Group
[Communication Standard]:
Select the wireless LAN standard.
Options: 802.11b
802.11g
802.11b/g
[802.11b] Group
[Channel]:
Set a channel for IEEE 802.11b.
The printer corrects channels that cannot be used due to country code settings.
Range: 1 to 14
[Max Rate]:
Select the maximum transmission rate for IEEE 802.11b.
The transmission rate is adjusted to a value enabling communication by the communicating device.
Options: 11 Mbps
5.5 Mbps
2 Mbps
1 Mbps
To Next Page
Loading...
