32
[802.11g] Group
[Channel]:
Set a channel for IEEE 802.11g.
The printer corrects channels that cannot be used due to country code settings.
Range: 1 to 13
[Max Rate]:
Select the maximum transmission rate for IEEE 802.11g.
The transmission rate is adjusted to a value enabling communication by the communicating device.
Options: 54 Mbps 48 Mbps 36 Mbps
24 Mbps 18 Mbps 12 Mbps
9 Mbps 6 Mbps 11 Mbps
5.5 Mbps 2 Mbps 1 Mbps
[WLAN Detail] Group
[ESS ID]:
Set an ESS ID, using up to 32 alphanumeric characters.
[Beacon Transmitting Interval]:
Select an interval between transmissions to the beacon.
Range: 1 to 65535 msec.
[Roaming Threshold]:
Select a threshold of roaming sensitivity.
Range: 0 to 99
[Country Code]:
This setting cannot be changed.
[Priority AP] Group
[Priority]:
Select ANY SSID/priority AP.
Options: ANY SSID OFF
ANY SSID ON / Priority AP OFF
ANY SSID ON / Priority AP ON / Other AP OFF
ANY SSID ON / Priority AP ON / Other AP ON
[MAC Address 1] [MAC Address 2] [MAC Address 3] [MAC Address 4] [MAC Address 5]:
Set MAC addresses for access points that you want to connect preferentially.
The numbers indicate order of priority.
Connection to the MAC addresses is made in the order of descending priorities.
Use 12 characters from “0” to “F” to enter addresses.
Entries are not case-sensitive.
When no address is entered, you can disable the current settings.
To Next Page
Loading...
