Toshiba B-FV4D-GL Series - 2.8 Printer Setup Utilities; 2.8 Self Print Test and Dump Mode Utilities

2. PRINTER SETUP ENGLISH VERSION EO1-33099
2.8 Self Print Test and Dump Mode Utilities
E2-10
2.8 Self Print Test and
Dump Mode Utilities
2.8.1 Self Print Test and
Dump Mode
These utilities are used to print out a test with details of the printer
settings and set the printer into Dump mode.
1. Turn off the printer power and install a media roll in the printer.
2. Press and hold the [FEED] Button while turning on the printer. The
status lamps (LED 1 and LED 2) will light up in the following order:
Orange  Green  Other colour sequences
3. Release the [FEED] Button when LED 1 lights in orange and LED 2
lights in green.
4. Press the [FEED] button.
5. The printer prints the self print test, and then enters Dump Mode.
6. To return to Online operation, turn the printer off, then on again.
Print test label sample
NOTE:
The following commands will
have no effect the test print. D,
AX, XS, Z2;1, Z2;2 (only the AY
command will)
B-FV4D-G PRINTER INFO.
PROGRAM VERSION 28OCT2015B-FV4 V1.6C
TPCL VERSION 15SEP2015 V1.4
CG VERSION 27FEB2014 V1.0
CHINESE VERSION 27FEB2014 V1.0
CODEPAGE VERSION 27FEB2014 V1.0
BOOT VERSION V1.4
KERNEL FONT VERSION 1.0.05
WLAN MODULE [Not installed]
BLUETOOTH MODULE [Not installed]
[PARAMETERS]
HW DETECT [0001110000100110]
TONE ADJUST(T) [-03]
TONE ADJUST(D) [+00]
FEED ADJUST [+0.0mm]
CUT ADJUST [+0.0mm]
BACKFEED ADJUST [+0.0mm]
X-COORD. ADJUST [+0.0mm]
CODEPAGE [PC-850]
ZERO SLASH [0]
FEED KEY [FEED]
EURO CODE [B0]
CONTROL CODE [AUTO]
MAXI CODE SPEC. [TYPE 1]
SENSOR SELECT [Transmissive]
PRINT SPEED [2ips]
FORWARD WAIT [OFF]
AUTO CALIB. [OFF]
MULTI LABEL [OFF]
AUTO THP CHK [OFF]
BASIC [OFF]
Reserved item1
Reserved item2
FLASH ROM [16MB]
SDRAM [32MB]
USB SERIAL NUM. [000000000001]