Toshiba B-SA4T Series - Page 14

1. OUTLINE EO10-33016A
1.5 Electronics Specifications
1-12
(2) USB (Standard interface)
c Standard: Conforming to Rev. 2.0
d Transfer type: Control transfer, Bulk transfer
e Transfer rate: Full speed (12M bps)
f Transfer control method: Data transfer is controlled by sending/receiving a status with the receive
buffer free space information.
g Receiving buffer: 1MB (shared with other interface)
(3) LAN interface (Standard interface)
c Constitution: 10 Base-T or 100 Base-TX LAN controller
d Protocol: TCP/IP
e Network specifications:
Function Description
LPR Server Function Supporting LPR protocol (Line Printer Daemon Protocol) which enables
printing via TCP/IP network.
WEB printer function When the printer is connected to a PC via TCP/IP network, browsing the
printer status, issuing media, checking or changing the printer settings, or
downloading the firmware are enabled.
Socket communication
protocol
Socket is an end point of a connection to other host computer via TCP/IP
network, which is used to send/receive data between the PC and the
printer.
Use of Socket Communication protocol allows a communication only by
reading/writing data to/from the socket.
E-mail function Commands are sent to the printer by an e-mail. This function allows
remote control of the printer.
f Receiving buffer: 1MB (shared with other interface)
(4) Serial interface (Optional interface)
A serial interface conforming to RS-232C is available when an optional serial interface board, B-
SA704-RS-QM-R, is installed in the printer.
c Communication mode: Full-duplex
d Transmission speed: 2400,4800,9600,19200, 38400, 115200 bps (selectable)
e Synchronization: start-stop synchronization
f Transmission parameter
 Parity: None, EVEN, ODD
 Start bit: 1-bit
 Stop bit: 1-bit or 2-bit
 Word length: 7-bit or 8-bit
g Error detection
 Parity check: VRC (Vertical Redundancy Checking)
 Framing error: This error occurs when no stop bit is found in the frame specified starting with
the start bit.
h Data entry code: ASCII, 8-bit code for European characters, 8-bit code for graphic
i Receiving buffer: 1MB (shared with other interface)
j Protocol: No-procedure method
CAUTION!
Do not directly connect the LAN cable wired
outside of a building to the LAN port provided on this product, as the LAN port on
this product is intended for indoor connection.
To connect such LAN cable to the product, be sure to use any communication equipment, like a router, a hub, or a modem
which
is located within the same building as the product.