4
June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 GENERAL OPERATION
4 - 9
(B) Pick-up failure in bypass ( )
(C) Set key copy counter
(D) Misfeed in equipment ( )
• During bypass feeding
Bypass feed clutch ON
"
1st transport sensor is not turned ON in a fixed period of time
"
Clear paper symbol is displayed ( ): E120
"
Copying operation is disabled
"
Solution: The bypass paper sensor is turned OFF by removing the paper from the bypass tray.
• When the key copy counter (optional) is pulled out from the equipment which installs it:
“Set key copy counter” displayed
"
Copying operation disabled
• When the counter is pulled out during copying:
Copying is stopped when the key copy counter is pulled out.
"
“Set key copy counter” displayed
"
Copying operation disabled
• Exit sensor detects jamming of the leading edge of paper.
"
Registration clutch ON
Fig.4-1
"
Less than 1.808 sec.
Exit sensor ON
If the exit sensor is not turned ON after 1.808
sec,
"
Paper jam (E010)%$ The copying operation
is stopped.
Registration clutch
Exit sensor
Timer
0
Paper jam (E010)
ON
ON
1.808sec.
To Next Page
Loading...
