e-STUDIO200L/202L/230/232/280/282 SCANNER June 2004 © TOSHIBA TEC
6 - 20
[D] Lens unit
(1) Take off the lens cover
(! P.6-18 "[B] Lens cover").
(2) Disconnect 1 connector form the SLG board.
(3) Remove 2 screws and take off the lens unit.
Fig. 6-26
Notes:
1. When installing, fix the lens unit with the
screws while pushing the unit to the rear
side.
2. Refer to “3.7.2 Lens Unit” in the Service
Handbook for the adjustment method.
3. Never attempt to loosen the screws (8
pc.) of the lens unit denoted with arrows.
4. Handle the unit with extra care. Do not
touch the adjusted area or lens. (Hold the
unit as shown in the figure at right.)
Fig. 6-27
Fig. 6-28
Lens unit
To Next Page
Loading...
