e-STUDIO200L/202L/230/232/280/282 DEVELOPMENT SYSTEM June 2004 © TOSHIBA TEC
12 - 10
[B] Developer unit
[C] Removing developer material
(1) Take out the process unit
(! P.12-9 "[A] Process unit").
(2) Take out the drum cleaner unit from the pro-
cess unit so that only the developer unit will
be left in it
(! P.11-9 "[B] Drum cleaner unit").
Notes:
1. Be careful not to touch or scratch the
drum surface at this time.
2. Do not deform the Guide Mylar by touch-
ing this.
Fig.12-8
Fig.12-9
(1) Take out the developer unit
(! P.12-10 "[B] Developer unit").
(2) Remove 2 screws and slide the developer
unit upper cover to the direction of the arrow
and take it off.
Fig.12-10
Drum cleaner unit
Developer unit
Guide mylar
Developer unit upper cover
To Next Page
Loading...
