12
June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 DEVELOPMENT SYSTEM
12 - 11
[D] Filling developer unit with developer material
Note:
When installing the developer unit upper
cover, make sure that the side seal comes
between the developer unit upper cover and
rubber seal on the cover.
Fig.12-11
(3) Remove the developer material from rear
side.
Note:
When removing the developer material, be
careful not to drop the developer material on
the gears of the developer unit.
Fig.12-12
(1) Install the developer nozzle jig on the devel-
oper bottle.
(2) Rotate the gear on the rear side of the devel-
oper unit to the direction of the arrow while
filling the developer unit with the developer
material. Spread out the developer material
over the developer sleeve.
Fig.12-13
Side seal
Rubber seal
Developer unit
upper cover
Lid
To Next Page
Loading...
