e-STUDIO200L/202L/230/232/280/282 DEVELOPMENT SYSTEM June 2004 © TOSHIBA TEC
12 - 12
[E] Auto-toner sensor
[F] Drum thermistor
[G] Guide roller / Developer sleeve
(1) Remove the developer material
(! P.12-10 "[C] Removing developer mate-
rial").
(2) Place the developer unit upside down. Dis-
connect 1 connector, remove 1 screw, and
then take off the auto-toner sensor.
Fig.12-14
(1) Remove the developer material
(! P.12-10 "[C] Removing developer mate-
rial").
(2) Disconnect 1 connector, remove 1 screw and
take off the drum thermistor.
Fig.12-15
(1) Remove the developer material
(! P.12-10 "[C] Removing developer mate-
rial").
(2) Remove 2 screws and take off the recovered
toner supply unit.
Fig.12-16
Connector
Auto-toner sensor
Connector
Drum thermistor
Recovered toner
supply unit
To Next Page
Loading...
