12
June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 DEVELOPMENT SYSTEM
12 - 13
(3) Remove 1 screw. Disconnect 1 connector
while taking off the recovered toner drive
unit. Remove 1 gear.
Fig.12-17
(4) Remove 2 plate springs fixing the doctor
sleeve on its both ends.
Fig.12-18
(5) Remove 2 screws on both ends of the doctor
sleeve and remove 2 coil springs.
Note:
When the screws on both ends of the doctor
sleeve are removed, be sure to adjust the
doctor sleeve gap (0.45±0.05 mm) after
assembling.
(Refer to Service Handbook Chap. 3.9)
Fig.12-19
Gear
Recovered toner drive unit
Connector
Plate spring
Plate spring
Screw Screw
Coil spring Coil spring
To Next Page
Loading...
