e-STUDIO200L/202L/230/232/280/282 DEVELOPMENT SYSTEM June 2004 © TOSHIBA TEC
12 - 14
(6) Remove 1 screw and plate spring.
(7) Remove 1 screw and take off the polarity
adjustment lever.
Note:
Make a note of the position where the polar-
ity adjustment lever is pointing. (Mark the
position if needed.) When reassembling,
match the polarity adjustment lever with the
previously marked position on the scale.
Fig.12-20
(8) Remove 2 screws and take off the bracket.
Fig.12-21
(9) Remove 1 E-ring and take off the guide roller
on the front side.
Fig.12-22
Plate spring
Polarity adjustment lever
Connector
Bracket
E-ring Guide roller
To Next Page
Loading...
