e-STUDIO200L/202L/230/232/280/282 DEVELOPMENT SYSTEM June 2004 © TOSHIBA TEC
12 - 20
[I] Replacement of Oil Seal
(1) Insert a fine screwdriver into the depression
of the oil seal to take it out.
(2) Push in a new oil seal parallel to the frame or
bushing (shown figure at right).
(3) Apply the grease (Alvania No.2; amount of 2
rice grains) on entire surface of the oil seal
evenly.
Note:
Wipe off the excessive grease.
Fig.12-38
OutsideInside
Oil seal
Grease
To Next Page
Loading...
