12
June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 DEVELOPMENT SYSTEM
12 - 19
(8) Remove the end section of the mixer-1.
(9) Remove the bushing and oil seal.
(Replacement of Oil Seal: ! P.12-20 "[I]
Replacement of Oil Seal")
Fig.12-35
(10) Take off the mixer-1.
Fig.12-36
(11) Remove the bushing on the rear side.
(12) Remove the oil seal.
(Replacement of Oil Seal: ! P.12-20 "[I]
Replacement of Oil Seal")
Fig.12-37
Oil sealBushing
End section of mixer-1
Mixer-1
Oil seal
Bushing
To Next Page
Loading...
