e-STUDIO166/206 © February 2007 TOSHIBA TEC CORPORATION All rights reserved
SCANNER
6 - 16
[F] CIS unit (CIS)
(4) Release 2 latches and take off the platen
sensor.
Fig. 6-19
(1) Take off the original glass.
" P.6-12 "[A] Original glass"
(2) Move the CIS unit to the right most position.
Fig. 6-20
Notes:
• Be sure to hold the CIS unit drive belt-1 to
move the CIS unit.
• When the CIS unit is moved, be sure not
to touch the shaft as the silicon oil is
applied on it.
Fig. 6-21
Platen sensor
CIS unit
CIS unit drive belt-1
To Next Page
Loading...
