e-STUDIO166/206 © February 2007 TOSHIBA TEC CORPORATION All rights reserved
SCANNER
6 - 18
[G] CIS case
(1) Take off the CIS unit.
" P.6-16 "[F] CIS unit (CIS)"
(2) Remove 1 screw and take off the belt stop-
per.
Note:
When installing the belt stopper, install it so
that the protrusion of the stopper fits in the V-
groove on the inside of the CIS unit drive
belt-1.
Fig. 6-25
(3) Take off the CIS case.
Fig. 6-26
Notes:
1. When installing the CIS case, be sure to
fit the shaft of the equipment in the shaft
guide attached on the bottom of the CIS
case.
2. When installing the CIS case, install it so
that the “L” shaped portion of the bottom
of the CIS case comes under the CIS unit
drive belt-1.
Fig. 6-27
Belt stopper
CIS unit
drive belt-1
CIS case
Shaft
Shaft guide
L shaped potion
To Next Page
Loading...
