6
© February 2007 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO166/206
SCANNER
6 - 19
[H] CIS unit drive belt-1
[I] CIS unit drive belt-2
(1) Take off the CIS case.
" P.6-18 "[G] CIS case"
(2) Loosen 1 fixing screw of the tension bracket.
Fig. 6-28
(3) Take off the CIS unit drive belt-1.
Note:
When assembling the CIS unit drive belt-1,
assemble it while the fixing screw is loos-
ened. Then tighten the fixing screw of the
tension bracket.
Fig. 6-29
(1) Take off the scanner top cover.
" P.6-13 "[B] Scanner top cover"
(2) Take off the right rear cover.
" P.2-22 "[I] Right rear cover"
(3) Take off the CIS unit drive belt-1.
" P.6-19 "[H] CIS unit drive belt-1"
(4) Loosen 2 fixing screws of the scan motor.
Fig. 6-30
Tension bracket
CIS unit drive belt-1
Scan motor
To Next Page
Loading...
