1
© February 2007 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO166/206
SPECIFICATIONS / ACCESSORIES / OPTIONS / SUPPLIES
1 - 3
!Density control ..................... Automatic density mode and manual density mode selectable in 7
steps
!Weight.................................. Approximately 32 kg (70.55 lb.) (excluding the developer material and
toner)
!Power requirements............. AC 110 V / 13.2 A, 115 V or 127 V / 12 A
220-240 V or 240 V / 8 A (50/60 Hz)
* The acceptable value of each voltage is ±10%.
!Power consumption ............. 1.5 kW or less (100 V series)
1.6 kW or less (200 V series)
* The electric power is supplied to the ADF and PFU through the equipment.
!Total counter ........................ Electronical counter
!Dimensions of the equipment
.................................................. W 600 x D 643 x H 462.5 (mm): See the figure below
Fig. 1-1
W
H
D
To Next Page
Loading...
