e-STUDIO166/206 © February 2007 TOSHIBA TEC CORPORATION All rights reserved
PAPER FEEDING SYSTEM
10 - 26
[S] Drawer detection switch (SW5)
[T] Registration sensor (S4)
(1) Take off the damp heater unit or dummy
plate.
" P.10-19 "[J] Damp heater unit (DH3) /
Dummy plate"
(2) Release the latch, take off the bracket while
lifting it up, and then disconnect the connec-
tor.
Fig. 10-50
(3) Release the latch and take off the drawer
detection switch from the bracket.
Fig. 10-51
(1) Take off the rear cover.
" P.2-22 "[J] Rear cover"
(2) Release the harness from the harness clamp
and disconnect 1 connector.
Fig. 10-52
Connector
Latch
Drawer detection
switch bracket
Drawer detection switch
Drawer detection switch bracket
Harness clamp
Connector
To Next Page
Loading...
