10
© February 2007 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO166/206
PAPER FEEDING SYSTEM
10 - 27
(3) Take off the damp heater unit or dummy
plate.
" P.10-19 "[J] Damp heater unit (DH3) /
Dummy plate"
(4) Take off the registration roller (metal).
" P.10-25 "[Q] Registration roller (metal)"
(5) Remove 1 screw.
Fig. 10-53
(6) Take off the registration guide while lifting it
up. Release the latch and take off the drawer
detection switch bracket.
Note:
Be careful not to break the harness which
connects the registration guide unit with the
drawer detection switch when taking off the
unit.
Fig. 10-54
(7) Take off the bracket of paper empty sensor.
" P.10-20 "[K] Paper empty sensor (S7)"
(8) Release the harness from the harness
clamp, disconnect the connector, remove 3
screws, and then take off the registration
guide.
Fig. 10-55
Screw
Registration guide unit
Drawer detection
switch bracket
Connector
Registration guide
To Next Page
Loading...
