e-STUDIO166/206 © February 2007 TOSHIBA TEC CORPORATION All rights reserved
DRUM RELATED SECTION
11 - 12
[D] Main charger
[E] Main charger grid
(3) Release the harness from the harness clamp
and pull out the discharge LED.
Fig. 11-14
(1) Take off the discharge LED unit.
" P.11-11 "[C] Discharge LED (ERS)"
(2) Pull out the main charger and take it off by
sliding it to the rear side.
Note:
Be careful not to touch or scratch the drum
surface at this time.
Fig. 11-15
(1) Take off the main charger.
" P.11-12 "[D] Main charger"
(2) Remove the spring and take off the main
charger grid.
Note:
Do not touch the mesh area of the grid.
Fig. 11-16
Discharge LED
Main charger
Main charger grid
Spring
To Next Page
Loading...
