Toshiba e-STUDIO 206

To Next Page

To Previous Page

DRUM RELATED SECTION

11 - 15

[J] Drum separation finger

[K] Recovery blade

(1) Take off the drum.

" P.11-14 "[H] Drum"

(2) Take off 2 drum separation finger units by

removing 1 screw each.

Note:

When replacing the drum separation fingers,

make sure that the drum has been taken off

first since the fingers may scratch the drum

surface.

Fig. 11-22

(3) Take off the drum separation finger with the

spring.

Note:

When the drum separation fingers have been

replaced, check if the pressure movement is

normal by moving them with your hands.

Fig. 11-23

(1) Take off 2 drum separation finger units.

" P.11-15 "[J] Drum separation finger"

(2) Remove 2 screws, and take off the whole

recovery blade with the bracket.

Fig. 11-24

Drum separation finger unit

Drum separation finger

Spring

Recovery blade

Toshiba e-STUDIO 206 - Page 175