Toshiba e-STUDIO 206 - Page 199

12
© February 2007 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO166/206
DEVELOPMENT SYSTEM
12 - 17
(10) Remove 3 screws. Take off 1 bearing and the
bracket.
Fig. 12-22
(11) Take off 4 gears and 1 timing belt.
Fig. 12-23
(12) Remove 1 E-ring, 1 pin and 1 pulley.
(13) Take off the guide roller on the rear side.
Fig. 12-24
Bearing
Bracket
Timing belt
GearGear
Pulley
Guide roller
E-ring
Pin