Toshiba e-STUDIO 206 - Page 202

e-STUDIO166/206 © February 2007 TOSHIBA TEC CORPORATION All rights reserved
DEVELOPMENT SYSTEM
12 - 20
(7) Remove 2 bushings and 2 oil seals on the
rear side.
(Replacement of Oil seal: " P.12-21 "[H]
Replacement of Oil Seal")
Fig. 12-31
(8) Remove the end section of the mixer-1.
(9) Remove the bushing and oil seal.
(Replacement of Oil seal: " P.12-21 "[H]
Replacement of Oil Seal")
Fig. 12-32
(10) Take off the mixer-1.
Fig. 12-33
Oil seal
Bushing
Oil sealBushing
End section of mixer-1
Mixer-1