12
© February 2007 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO166/206
DEVELOPMENT SYSTEM
12 - 19
(3) Remove 1 screw and take off the tensioner
bracket.
(4) Remove 2 screws and take off the holder.
Fig. 12-28
(5) Remove 2 bushings and 2 oil seals from the
holder.
(Replacement of Oil seal: " P.12-21 "[H]
Replacement of Oil Seal")
Fig. 12-29
(6) Take off the mixers-2 and -3.
Fig. 12-30
Holder
Tensioner bracket
Oil seal
Bushing
Mixer-3
Mixer-2
To Next Page
Loading...
