e-STUDIO166/206 © February 2007 TOSHIBA TEC CORPORATION All rights reserved
FUSER / EXIT UNIT
13 - 18
(3) Remove 2 springs.
Note:
When installing the spring, be sure to hang
the spring on the upper hook.
Fig. 13-27
(4) Take off each 1 pressure lever on both front
and rear sides.
Fig. 13-28
(5) Take off 2 bushings and then take off the
pressure roller while sliding the pressure
roller to the rear side.
Notes:
• Do not drop the pressure roller when you
lift it up because it is quite heavy.
• Be sure to install the pressure roller from
the rear side (pressure roller ground plate
side) in order not to deform the pressure
roller ground plate.
Fig. 13-29
Spring
Pressure lever
Pressure roller
Bushing
Pressure roller
ground plate
Bushing
To Next Page
Loading...
