13
© February 2007 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO166/206
FUSER / EXIT UNIT
13 - 19
[I] Center thermistor / Side thermistor / Edge thermistor (THMS1/THMS2/THMS3)
[J] Fuser thermostat (THMO1)
(1) Take off the fuser roller.
" P.13-17 "[G] Fuser roller"
(2) Remove each 1 screw of the thermistors,
and then take off each thermistor by releas-
ing its harness out of the harness clamp.
Fig. 13-30
Note:
When installing the thermistors, do not mix
up the installation positions of the side ther-
mistor and the edge thermistor by telling
them apart by the length of their harnesses.
Fig. 13-31
(1) Take off the fuser roller.
" P.13-17 "[G] Fuser roller"
(2) Remove 2 screws and take off the fuser ther-
mostat.
Fig. 13-32
Thermistor
Center thermistor
Side thermistor
Edge thermistor
Fuser thermostat
To Next Page
Loading...
