Toshiba E-studio 281c - Deleting the Print Queue

2. Installing Client Software
174 Printing Guide — Installing Client Software for UNIX
2. To manually edit the configuration file (/etc/lp/interfaces/
<queue name>.conf), add a line that consists of the parame-
ter and value.
• For example, to change the default orientation to Landscape, add the follow-
ing line:
orient= “LANDSCAPE”
— Deleting the Print Queue
There are two ways to delete the print queue: one is deleting a print queue using
est451crm, and the other is deleting a print queue manually without using est451crm.
 P.174 "Deleting a Print Queue Using est451crm"
 P.174 "Deleting a Print Queue Manually"
Deleting a Print Queue Using est451crm
When you want to delete the queue using est451crm, perform the following procedure.
Deleting a print queue
1. Log on to the root account.
2. Enter the following command:
est451crm <queue name>
SUPPLEMENTS: • This command uses the system’s lpadmin command to delete the print queue and
configuration file.
• Please restart the lpd under Linux.
Deleting a Print Queue Manually
You can also configure the print queue by adding a print queue manually.
The procedure varies depending on the operating systems.
 P.174 "Deleting a print queue manually on Solaris"
 P.174 "Deleting a print queue manually on HP-UX"
 P.175 "Deleting a print queue manually on IBM AIX"
 P.175 "Deleting a print queue manually on Linux"
 P.176 "Deleting a print queue manually on OpenUNIX"
Deleting a print queue manually on Solaris
1. Log on to the root account.
2. Enter the following command:
lpadmin -x <queue name>
3. Enter the following command:
rm /etc/lp/interfaces/<queue name>.conf
Deleting a print queue manually on HP-UX
1. Log on to the root account.