Toshiba E-studio 281c - Stapling and Hole Punching

3. Printing
Printing Guide — Printing from Windows 247
NOTE: This is only available for PCL5c printer driver and PS3 printer driver.
Printing a color document in gray scale
1. Display the Setup tab and select “Mono” at the “Color” drop
down box.
2. Set other print options you require and click [OK].
3. Click [OK] or [Print] to send a print job.
• The print job is printed in gray scale.
— Stapling and Hole Punching
You can staple and punch the paper.
NOTES: • Stapling is not available if a finisher is not installed.
• Hole Punching is not available if a hole punch unit is not installed.
Stapling the paper
1. Display the Setup tab and select how to staple at the “Staple”
drop down box.
Upper Left — Select this to staple the printed document in the upper left.
Center Top — Select this to staple the printed document double in the upper
side.
Upper Right — Select this to staple the printed document in the upper right.
Middle Left — Select this to staple the printed document double in the left.
Center Double — Select this to fold and staple the printed document double in
the center.
NOTES: • The selectable options vary depending on the paper size.
• “Center Top” can be selected only when the Saddle-stitch Finisher is installed and
configured on the Configuration tab.
2. Set other print options you require and click [OK].
3. Click [OK] or [Print] to send a print job.
• The output is stapled for each copy.