Toshiba e-Studio 350 - Setup Flow for Macintosh Printing

28 Network Administrator’s Guide — Setup Flow for Printing Features
This equipment supports the PSERVER in the NetWare 4.x bindery emulation mode, NetWare
4.x NDS mode, NetWare 5.x NDS/NDPS mode, and NetWare 6.x NDS/NDPS mode.
Setup procedure
Step 1: Setting up the NetWare print server.

P.171 "Setting up NetWare Print Server"
Step 2: Setting up the TCP/IP and the HTTP Network Service to enable TopAc-
cess.
You should set the TCP/IP and HTTP Network Service from the Touch Panel Display the
first time you use it, to make TopAccess available. Please see the User Functions Guide to
configure the TCP/IP and HTTP Network Service from the Touch Panel Display, or from
TopAccess.
 P.53 "Setting up the TCP/IP"
 P.58 "Setting up the HTTP Network Service"
Step 3: Setting up the IPX/SPX if this equipment is used in the IPX/SPX net-
work.

P.54 "Setting up the IPX/SPX"
Step 4: Setting up the NetWare Session.

P.58 "Setting up the NetWare Session"
Step 5: Setting up the SLP Session.
If the NetWare file server is connected to the equipment over the TCP/IP network, enable the
SLP.
 P.56 "Setting up the SLP Session"
Step 6: Setting up the NetWare Print Service.

P.93 "Setting up the NetWare Print"
Step 7: Advise users to install the Client Software for Novell printing.
Users can install the printer drivers for Novell printing from the Client1 CD-ROM and map
the queue created in the NetWare server. For more information about the Novell installation,
please see the Printing Guide.
In the Novell network, users must install following client software for printing:
• Printer Drivers
• TopAccessDocMon
• Agfa Font Manager
Setup Flow for Macintosh Printing
This equipment supports AppleTalk printing and LPR printing for Macintosh computers. The
configurations required are different for each printing system.
System Requirements
Macintosh printing applies the following Mac OS computers and environments:
Display Resolution: 1024 x 768 dots or more
OS: Mac OS 8.6 to 9.x, Mac OS X
Protocol: TCP/IP or AppleTalk (Ethernet)
Printer Driver: LaserWriter 8 printer driver version 8.6.5 or later
(not required for Mac OS X 10.2.4 or later)