78 Network Administrator’s Guide — Setting up Save as file Settings
9) Allow user to select network folder to be used as a destination
Select this to allow users to specify a network folder as a destination. Otherwise, select
“Allow the following Windows network folder to be used as a destination”.
Setting up the N/W-Fax Destination
You can configure a network folder to store documents that are sent using the N/W-Fax driver
with the Save as file option enabled.
1) Do not allow any network folder to be used as a destination
Select this to not allow any network folders to be used as Save as file destinations for N/
W-Faxes documents. When selected, users can only save an N/W-Fax document with the
Save as file option enabled to local storage.
2) Use Network Folder Destination
Select this to allow network folders to be used as Save as file destinations for N/W-Fax doc-
uments. When selected, set the N/W-Fax Folder settings to specify which network folder to
use.
Setting up the N/W-Fax Folder
In the N/W-Fax Folder, you can specify in which network folder N/W-Fax documents are saved.
1) Protocol
Select the protocol for uploading an N/W-Fax document to a network folder.
• SMB — Select this to upload an N/W-Fax document to the network folder using the
SMB protocol. SMB can be used in a Windows network when Windows file sharing
service is enabled.
• FTP — Select this to upload a file to the FTP server.
2) Server Name
Enter the FTP server name or IP address where an N/W-Fax document will be sent. For
example, to send an N/W-Fax document to the “ftp://192.168.1.1/user/nw-fax” FTP folder
in the FTP server, enter “192.168.1.1” in this field. This must be entered only when you
select “FTP” as the protocol. You can specify the directory at the “Network Path” field.
3) Port Number (Command)
Enter the port number to be used for controls, if you select “FTP” as the protocol. Generally
“-” is entered for the control port. When “-” is entered, the port number, that is set at “FTP
1
2
1
2
3
4
5
6
7
To Next Page
Loading...
