5.[Administration] Tab Page
42 [Setup] Item List
Setting up DNS Session
In DNS Session, you can specify the DNS server to enable the FQDN (Fully Qualified Domain Name) rather than the IP
address on specifying each server address such as SMTP server and POP3 server.
3 Manual You assign the IPv6 address, prefix and default gateway manually. In this
mode, you can assign one IPv6 address to this equipment.
IP Address — Assign the IPv6 address for this equipment. Specify within the
range from 0:0:0:0:0:0:0:0 to ffff:ffff:ffff:ffff:ffff:ffff:ffff:ffff.
You cannot specify the following characters.
For Link-local addresses: “FE80” at the beginning.
For multicast addresses: “FF” at the beginning. (For example, “FF00”.)
For loopback addresses: “::1” at the end.
For IPv4-compatible/IPv4-mapped addresses: “::ffff:x.x.x.x” at the end (x.x.x.x
is an IPv4 Address).
Prefix Length — Assign the prefix length for the IPv6 address. Specify within
the range from 0 to 128. “0” is set as the default.
Gateway — Assign the default gateway address. Specify within the range from
0:0:0:0:0:0:0:0 to ffff:ffff:ffff:ffff:ffff:ffff:ffff:ffff.
You cannot specify the following characters.
For Site-local addresses: “FEC0” at the beginning.
For multicast addresses: “FF” at the beginning. (For example, “FF00”.)
For loopback addresses: “::1” at the end.
For global addresses: “2” or “3” at the beginning. (For example, “2001”,
“2002”, “3FFE”.)
For IPv4-compatible/IPv4-mapped addresses: “::ffff:x.x.x.x” at the end (x.x.x.x
is an IPv4 Address).
Use DHCPv6 Server for Options — Select this check box to use the optional
information (IPv6 address for the DNS server, etc.) which is issued from the
DHCPv6 server.
When [Manual] is selected, a stateful address cannot be set.
If the selected IPv6 address is already assigned, DAD (Duplicate Address Detection) detects it and notifies
you on the LCD screen of this equipment.
4 Use Stateless Address Use the IPv6 addresses (Stateless addresses) issued from routers.
IP Address — Stateless Addresses obtained from routers are displayed. Up
to 7 IPv6 addresses can be retained.
5 Use Stateful Address Use the Stateful address issued from DHCPv6 server.
IP Address — A stateful address, Prefix Length and Gateway obtained from
DHCPv6 Server are displayed.
Item name Description
To Next Page
Loading...
