5.[Administration] Tab Page
[Setup] Item List 43
[Administration] Tab Page
Setting up SMB Session
In SMB Session, you can specify the SMB network properties to enable this equipment to access a Microsoft Windows
Network. When you enable the SMB, users can also browse the network folders. You can also specify the WINS server
address if you are using the WINS server for resolution to save files on different subnets.
Item name Description
1 Enable DNS Select whether the DNS server is enabled or not. [Enable] is set as the default.
2 Enable DNS(IPv6) Select whether the DNS server is enabled or not in IPv6. [Disable] is set as the
default.
3 Primary DNS Server Address Specify the IP address of the primary DNS server when the DNS service is
enabled. Specify within the range from 0 0 0 0 to 255 255 255 255.
4 Secondary DNS Server
Address
Specify the IP address of the secondary DNS server when the DNS service is
enabled, as you require. Specify within the range from 0 0 0 0 to 255 255 255
255.
5 Primary DNS Server Address
(IPv6)
Specify the IPv6 address of the primary DNS server when the DNS service is
enabled in IPv6. Specify within the range from 1:1:1:1:1:1:1:1 to
ffff:ffff:ffff:ffff:ffff:ffff:ffff:ffff.
You cannot specify the following characters.
For multicast addresses: “FF” at the beginning. (For example, “FF00”.)
For loopback addresses: “::1” at the end.
For IPv4-compatible/IPv4-mapped addresses: “::ffff:x.x.x.x” at the end (x.x.x.x
is an IPv4 Address).
6 Secondary DNS Server
Address (IPv6)
Specify the IPv6 address of the secondary DNS server when the DNS service is
enabled in IPv6, as required. Specify within the range from 1:1:1:1:1:1:1:1 to
ffff:ffff:ffff:ffff:ffff:ffff:ffff:ffff.
You cannot specify the following characters.
For multicast addresses: “FF” at the beginning. (For example, “FF00”.)
For loopback addresses: “::1” at the end.
For IPv4-compatible/IPv4-mapped addresses: “::ffff:x.x.x.x” at the end (x.x.x.x
is an IPv4 Address).
7 Host Name Specify the host name.
8 Domain Name Specify the domain name.
Item name Description
1 Primary WINS Server Specify the IP address of the primary WINS server when the WINS server is
used to provide the NetBIOS name in your local area network. Specify within
the range from 000:000:000:000 to 255:255:255:255. This option would be
more useful to access this equipment using the NetBIOS Name from a
different subnet.
1
2
To Next Page
Loading...
