Toshiba E-STUDIO2829A - Page 46

5.[Administration] Tab Page
46 [Setup] Item List
 Setting up POP3 Network Service
In POP3 Network Service, you can specify the POP3 server to receive Emails.
This item is not available for e-STUDIO2323AM/2823AM.
 Setting up FTP Client
In FTP Client, you can specify the default port number used for the Save as file using the FTP protocol.
This item is not available for e-STUDIO2323AM/2823AM.
Item name Description
1 POP3 Server Address Enter the IP address or FQDN (Fully Qualified Domain Name) of the POP3
server. You can enter up to 128 alphanumerical characters, symbols, and
spaces.
If you use FQDN to specify the POP3 server, you must configure the DNS server and enable the DNS in the DNS
Session.
2 Account Name Enter the account name for this equipment to access the POP3 server. You can
enter up to 96 alphanumerical characters and symbols.
3 Password Enter the password for this equipment to access the POP3 server. You can
enter up to 32 alphanumerical characters and symbols.
The password input is displayed in asterisk symbols.
4 Port Number Enter the port number to access the POP3 server. The SSL port number
depends on the port setting in the POP3 server. You can enter a value in the
range from 1 to 65535. Generally the default value “110” is used.
Item name Description
1 Default Port Number Enter the port number to access the FTP site. The port number depends on the
port setting in the FTP site. You can enter a value in the range from 1 to 65535.
Generally the default value “21” is used.
1
2
3
4
1