Toshiba FC-22 - General Maintenance Checklist

General Maintenance Checklist FC-15
Section Item to inspect Cleaning Coating
Replace every Operation Remarks
1K copies check <P-1>
1. Developer material (Y, M, C) 20 ∗9
2. Doctor blade (20/40) > ∗1
3. Developer unit drum seal (40) > ∗10
4. Front/rear sides of developer unit (40) ∗2
5. Oil seal portion AV
6. Cleaning blade 40 ∗3
<P23-I13>
7. Recovery blade (40) > ∗4
8. Felt seals on both ends of the cleaning blade (40) >
9. Entire developer/cleaner unit (40) ∗8
10. Main charger case (40) ∗7
11. Dischiarge LED (40)
12. Wire cleaning pad 40  <P22-I21>
13. Main charger wire 40 ∗7
<P22-I15>
14. Main charger grid 40 <P22-I24>
15. Main charger contact (40)
16. Drum 40 ∗5
<P22-I38>
17. Drum shaft (40)
18. Drum thermister (40)
19. Toner recovery auger drive (40) W
20. Toner cartridge drive gear W
21. Ozone filter 40 ∗6
<P6-I37>
22. Toner bag 30 Key-operator’s
item
<P33-I33>
23. Upper fuser roller 60 ∗11
<P27-I17>
24. Lower fuser roller 60 ∗12
<P27-I4>
25. Separation fingers 60 ∗14
<P28-I31>
26. Upper oil roller 20 ∗13
<P28-I56>
27. Upper cleaning roller 20 ∗13
Fuser unit <P28-I57>
28. Lower oil roller 60 ∗13
<P28-I11>
29. Lower cleaning roller 60 ∗13
<P28-I12>
30. Upper thermistors A(20) >
31. Lower thermistors A(20) >
32. Fuser roller inlet guide A(60)
33. Fuser roller exit guide A(60)
34. Paper exit roller A
Processing
unit (EPU)
(Only Black)
related
parts)
January 2000 © TOSHIBA TEC 2 - 5 - 1 FC-22 PREVENTIVE MAINTENANCE
Processing
unit Around
EPU area