FC-22 TROUBLESHOOTING 4 - 2 January 2000 © TOSHIBA TEC
Where was the paper stopped?
Near the exit sensor (paper not damaged)
Is the registration sensor functioning properly? (Does its actuator return
smoothly?)
1. Check the test mode 03 and see if the registration sensor is
valid.
2. Reconnect the registration sensor connector.
Repair if the actuator is displaced.
Before reaching the fuser unit
Did the paper stop, curling upward excessively?
Replace the paper in the cassette.
From on the transfer belt up to the exit sensor
Do the size of paper and the size plate indication match?
Make the sizes match.
Is the transfer belt moving?
(To C37 )
E03 Paper remaining inside the copier at power ON
Is any paper remaining inside the copier?
Remove the paper.
Refer to E01 , E02 and E11 to E26 .
NO
▼
YES
▼
▼
▼
▼
▼
YES
▼
NO
▼
YES
▼
YES
▼
NO
▼
To Next Page
Loading...
