January 2000 © TOSHIBA TEC 1 - 9 FC-22 ADJUSTMENT
Digital key Icon Item Condition
A Bypass paper-width sensor 0 Refer to Table 1.
B Bypass paper-width sensor 1 Refer to Table 1.
C Bypass paper-width sensor 2 Refer to Table 1.
5
D Bypass paper-width size sensor 3 Refer to Table 1.
E Bypass paper sensor 1: No paper
F Bypass unit open/close switch 1: Unit is open
G Side door open/close switch 1: Side door is open
H Bypass unit is installed or not 0: Unit is installed
A LCF paper empty sensor 1: No paper
B LCF lower-limit sensor 1: Tray limit (lower)
C LCF tray-up sensor 1: Tray limit (upper)
D LCF tray-down switch 0: Switch is ON
6 E LCF paper supply door switch 1: Door is open
F LCF is installed or not 0: LCF is installed
G ADU motor rotation status 0: Normal rotation
(Motor is rotating by 03 Output mode)
H ADU unit is installed or not 0: ADU unit is installed
A ADU paper jam switch 1: Paper exist
B ADU paper empty switch 0: No paper
C ADU end switch 1:
End guide is positioned at home position
7
D ADU side switch 1:
Side guide is positioned at home position
E—
F Total counter is installed or not 0: Total counter is installed
G Key copy counter is installed or not 0: Key copy counter is installed
H—
A Developer removal shutter home position sensor 0: Shatter is closed
B—
C Transfer belt unit is installed or not 0: Unit is installed
D—
8
E Color developer motor rotation status 0: Normal rotation
(Motor is rotating by 03 Output mode)
F Black developer motor rotation status 0: Normal rotation
(Motor is rotating by 03 Output mode)
G Transfer belt limit switch 0:
Transfer belt is black mode position
H Transfer belt home position switch 0:
Transfer belt is color mode position
To Next Page
Loading...
