January 2000 © TOSHIBA TEC 5 - 9 FC-22 FIRMWARE UPDATING
Further procedure is the same as normal sequence.
Firmware Version Up Mode
Recovery mode : target 4–6 failed.
> make a connection from PC
Firmware Version Up Mode
Target: #3
Recovery mode : target 4–6 failed.
Established serial connection with PC.
> Press START key to install new
firmwares.
10. Recovery mode
When you turn ON the power after an error occurs, you'll see following display.
Connect with dial-up network (see procedure 3), and the display changes as follows.
To Next Page
Loading...
