Toshiba Q9+ - Page 243

Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
https://www.toshiba.com/tic/ 231
Input Function Target 1
Program My Function My Function Unit 3
This parameter plays a role in the setup of the My Function fea-
ture by selecting the functionality of the programmable Input
Function Target 1 terminal.
This setting assigns the function of the programmable Input
Function Target 1 terminal to any one of the user-selectable func-
tions listed in Table 11 on pg. 256, Table 12 on pg. 257, or Table
14 on pg. 260.
See F977 for additional information on this parameter.
Direct Access Number —
F912
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — No
Input Function Command 1
Program My Function My Function Unit 3
This parameter is used to assign a user-selected logical operator
to two user-selected Input Function Target variables, enable a
counter/timer function, or perform a hold/reset function.
Table 15 on pg. 262 lists the available selections. Their use and
selection requirements are described in an example at F977.
Direct Access Number —
F913
Parameter Type — Selection List
Factory Default — 0 (NOP)
Changeable During Run — No
Input Function Target 2
Program My Function My Function Unit 3
This parameter plays a role in the setup of the My Function fea-
ture by selecting the functionality of the programmable Input
Function Target 2 terminal.
This setting assigns the function of the programmable Input
Function Target 2 terminal to any one of the user-selectable func-
tions listed in Table 11 on pg. 256, Table 12 on pg. 257, or Table
14 on pg. 260.
See F977 for additional information on this parameter.
Direct Access Number —
F914
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — No
Input Function Command 2
Program My Function My Function Unit 3
This parameter is used to assign a user-selected logical operator
to two user-selected Input Function Target variables, enable a
counter/timer function, or perform a hold/reset function.
Table 15 on pg. 262 lists the available selections. Their use and
selection requirements are described in an example at F977.
Direct Access Number —
F915
Parameter Type — Selection List
Factory Default — 0 (NOP)
Changeable During Run — No
F912 – F916