84 https://www.toshiba.com/tic/
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
Automatic Function Selection
Program Utilities Display Parameters
This parameter setting is used to configure multiple parameters
with the setting of only one parameter. From the selection below,
multiple parameters may be set as indicated in the table.
Once set, the selected configuration is placed in effect and
remains in effect until this parameter is changed or the individual
settings are changed.
Set this parameter to Disable to set these parameters individu-
ally.
Note: After performing the desired selection, the EOI display
returns to Disabled though the selected function has been
carried out (i.e., without this, if selection 1 is performed,
F004 and F207 would hold the RR terminal setting
regardless of attempts to change the settings individually).
Settings:
0 — Disabled
1 — RR
2 — V/I
3 — Select RR or V/I by TB (Terminal Board)
4 — Keypad Frequency and Command from TB
5 — Keypad Frequency and Command
6 — Coast Stop
Direct Access Number —
F040
Parameter Type — Selection List
Factory Default — Disabled
Changeable During Run — No
User Selections
0 1 2 3 4 5 6
Related
Params
Default
Settings
Dis-
abled
RR V/I
RR or
V/I via
TB
Keypad/
Freq.
CMD/TB
Keypad
Freq/CMD
Coast
Stop
Com
Mode
F003
Terminal
Board
N/C
Terminal
Board
Keypad
Freq
Mode 1
F004
RR N/C RR N/C RR Keypad N/C
S3
Terminal
F117
Preset
Speed 3
N/C
Freq.
Ref.
Priority
N/C ST
Freq
Priority
F200
Terminal
Board
N/C Terminal Board N/C
V/I Setup
F201
0.0% N/C 20.0% N/C N/C
Freq
Mode 2
F207
V/I N/C RR V/I Keypad N/C
Always
On F110
Not
Assigned
N/C 0
N/C = No Change — the setting remains as it was before setting
parameter F040.
F040 – F100
To Next Page
Loading...
