86 https://www.toshiba.com/tic/
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
Input Terminal Priority
Program Terminal Input Special Functions
This parameter is used to allow the Jog and DC Injection Brak-
ing input signals to control the ASD when received via the Termi-
nal Board even though the system is in the Local mode.
With this parameter enabled, a Jog command or a DC Injection
Braking command received from the Terminal Board will receive
priority over commands from the EOI.
See F260 for additional information on using the Jog function.
See F250 – F252 for additional information on DC Injection Brak-
ing.
Settings:
0 — Disabled
1 — Enabled
Direct Access Number —
F106
Parameter Type — Selection List
Factory Default — Disabled
Changeable During Run — No
16-Bit Binary/BCD Input
Program Terminal Input Special Functions
The extended terminal function is used with the Expansion IO
Card Option (P/N ETB004Z).
This parameter defines the format of the binary or BCD data
when using the option card.
Note: The Expansion IO Card Option 2 option board is required to
use this terminal.
See the Expansion IO Card Option 1 instruction manual (P/N
58685) for additional information on the function of this terminal.
Settings:
0 — None
1 — 12-Bit Binary
2 — 16-Bit Binary
3 — 3-Digit BCD
4 — 4-Digit BCD
5 — Inverted 12-Bit Binary
6 — Inverted 16-Bit Binary
7 — Inverted 3-Digit BCD
8 — Inverted 4-Digit BCD
Selections using 16-bit binary or 4-digit BCD will require the con-
figuration of terminals S1-S4 on the Terminal Board as binary bits
0 – 3 (F115 – F118). The Frequency Mode 1 (F004) parameter
must be set to Binary/BCD.
For proper scaling of the binary or BCD input, parameters F228 –
F231 must be configured.
Direct Access Number —
F107
Parameter Type — Selection List
Factory Default — None
Changeable During Run — No
F106 – F109
To Next Page
Loading...
