IF08CZ10 April, 2019 - 34 -
INTERFACE (cont’d)
Digital Input Descriptions **
Name Description
MP_OLU_LPL_N OilLubULowPressLineN 1:Normal
MP_PRD_A_ PressReliefDevAlarm 0:Alarm
MP_PRD_TR_ PressReliefDevTrip 0:Trip
MP_SPH_IL_ SpaceHeater I/L SW 0:Interlocked
MP_SPH_MCC_F_ SpaceHeaterMCC Fault 0:Fault
MP_SPH_ON SpaceHeater On 1:On
MP_SW_TM_H_ StatorWindTempHigh 0:Temperature High
MP_WD_TM_A_ WindingTempAlarm 0:Alarm
MP_WD_TM_TR_ WindingTempTrip 0:Trip
MP_WLK1_ WaterLeakage1 0:Leakage
N.U. Not used
OH_ACL_ ACL overheating
PLC PLC Control 1:PLC Control (Always set to 1)
PR_ST PID control start
QSTOP Emergency stop 1: Emergency stop command
R Reverse jog run command 1: Reverse inching command
R_LMT_ Reverse limit
R_TEN Reverse rotation command
1: Reverse winding, 0: Forward winding
(Torque direction when torque is controlled)
RATE_CHG Optional rate selection
SC_PPI Speed control P/PI switching P control when 1, PI control when 0
SEL_DI
Operation (Local/Remote) system
selection
0: Local 1: Remote
SEL_MRH MRH Enable
SPA0 Spare 0
SPA1 Spare 1
SPA2 Spare 2
SPA3 Spare 3
SPA4 Spare 4
SP_DN Speed down Slow down while on
SP_UP Speed up Speed up while on
ST Torque control selection 1: Tension control, 0: speed control
START0 Start button (Local) One shot to start (SEL=0)
START1 Start button (Remote) One shot to start (SEL=1)
STOP0 Stop button (Local) One shot to stop (SEL=0)
STOP1 Stop button (Remote) One shot to stop (SEL=1)
UVS External safety switch Operation enabled when 1
XFR Transfer command
XFR_CHK Synchronization relay input 1 when Synch check relay is satisfied
“**” The function of many operation signals can be reversed via sign bit settings if needed.
To Next Page
Loading...
