10. PROGRAMMING PROCEDURES
■ Title and Contents of Programming Menu
10- 2
■ Title and Contents of Programming Menu
NO. TITLE
MENU
PAGE
ITEM
NO.
CONTENTS Page
1 PLU DATA EDIT 1 0 CHANGE UNIT PRICE 10-4
2 PLU DATA 1 1 PROGRAM/CHANGE/DELETE PLU 10-5
3 INGREDIENT 1 2 PROGRAM/CHANGE INGREDIENT 10-7
4 NUTRITION 1 3 PROGRAM/CHANGE NUTRITION FACTS TABLE 10-8
5 CONFIRMATION LABEL 1 4 VERIFY THE PROGRAMMING DATA OF PLU 10-12
6 MESSAGE 1 5 PROGRAM MESSAGE/ADDRESS 10-13
7 MSG. COMBINATION 1 6 PROGRAM MESSAGE ON DISPLAY AND TIME 10-14
8 SPECIAL INFO. 1 7 PROGRAM SPECIAL INFORMATION 10-16
9 GRADE LINE 1 8 PROGRAM GRADE LINE 10-16
10 SPEED KEY SET 1 9 ASSIGN COMMON PLU TO SPECIFIC SPEED KEY 10-17
11 PRT LOCATION 2 0 SELECT LABEL FORMAT AND ADJUST 10-18
12 DATE TIME 2 1 PROGRAM DATE/TIME/MACHINE #/STORE CODE 10-20
13 CMT/PL-3 2 2 BACK-UP/LOAD DATA OF PLU/ING/NUTRI./SPEED KEY 10-20
14 ON-LINE/LOCAL 2 3 SET PARAMETERS FOR TMCC 10-23
15 LON SYSTEM 2 4 SET PARAMETERS FOR LON 10-24
16 INITIAL SET 2 5 SET INITIAL PARAMETERS
17 BAR CODE FORMAT 2 6 PROGRAM BARCODE FORMAT 10-26
18 TITLE 2 7 PROGRAM/CHANGE TITLE ON DISPLAY/PRINT 10-28
19 LOGO 2 8 SEND/RECEIVE LOGO DATA 10-29
20 IDIOM 2 9 PROGRAM IDIOM 10-31
21 VENDOR NAME 3 0 VENDOR NAME 10-31
22 FREE FORMAT 3 1 PROGRAM FREE FORMAT 10-32
23 LAN SYSTEM 3 2 PROGRAMS PARAMETERS FOR LAN
Table 1.
NOTE: Menu No. 16 and 23 are program for use of dealers. Contact a TOSHIBA TEC
representative if you desire to use them. When you enter one of these menus by
mistake, press key to return to Main Menu.
ESC
.
To Next Page
