Toshiba TEC EO1-32003 - In-Line;Local

10. PROGRAMMING PROCEDURES
10.14 IN-LINE/LOCAL
10-23
10.14 IN-LINE/LOCAL
Menu Page: 2
Item No.: 3
When the H-9100N is used as a satellite in an in-line system, the “ID #” and “Transmission delay time”
can be set by the following procedure.
NOTES:
1. The TMCC baud rate is fixed to 4800 BPS.
2. After setting the ID #, turn the power switch OFF and ON again.
3. This setting is not available when the Initial set #13-6 is set to 1 (LAN: allowed).
■ Table 5: Transmission Delay Time Table
TR-Time (ms) TR-Time (ms)
1 20 to 39 6 120 to 139
2 40 to 59 7 140 to 159
3 60 to 79 8 160 to 179
4 80 to 99 9 180 to 199
5 100 to 119
3
PROG.
ESC.
<MENU>
Page 2
Main
<MENU>
ENTER
The transmission delay
time can be set when in-
line system is selected for
TMCC.
(Refer to Table 5)
Select mode
TMCC
Set ID numbers
(Range: 0 to 255)
ENTER
OFF-line
l
◇
The default is 3.
<MENU>
Page 2
l